The Classic Machinery Network

No idea really what they are, what they fit, or where they came from!
2 off ripper teeth (?), main pin 40mm, ram pin 30mm, length 600mm, width 120mm. Apologies for the metric measurements, all rather approximate. Open to offers, collect from NE Hampshire.

Boooo, really could do with a ripper tooth on the JCB for tree roots, but of course I have 45mm pins on the back actor.

Looks like they are for a Case two different pin sizes, If the bracket is also narrower at the back that would confirm it for Case 580/590 fitment.

Ah, there were a pair of IHC 3500s here at one time...