The Classic Machinery Network

I have been busy, and CADed up some better wheels for the Dalpol JCB 3, that I recently bought



, then today had them polyjet 3d Printed



.... now all I have to do is make it !

They are much better wheels.
Apart from wheels it is not a bad little model considering it came out when the JCB 3 was a current product !
I was going to combine it with an Oxford Fordson Major Skid but never got round to it. (like many other projects , perhaps now is the time )

Craig

Very impressive Andy Is this the same kit that was the Airfix one?

Jeremy

.... yes - it is a re-make of the old Airfix kit

https://www.amazon.co.uk/Dapol-Model-Railway-JCB-Plastic/dp/B005FDX4KU/ref=sr_1_48?crid=3LCU4HPDF6MRG&keywords=dapol+model+railway+kits&qid=1585314952&sprefix=dalpol+%2Caps%2C148&sr=8-48

.... mine was a little cheaper from a local model railway shop

.... that’s it for a bit, have had to order some new paints ! all dried up, they don’t make them like they used to, only had that yellow since the early 80s ! ( wheels only held on with blue tack currently )

Jeremy Rowland wrote:Very impressive Andy Is this the same kit that was the Airfix one?

Jeremy

I never came across this model as a digger mad kid despite re-fighting the second world war with lots of other airfix kits !
I think it was marketed more to the model rail crowd as a Lowmac wagon and was never seen in Redcar Woolies or model shop
Caught up with it many years later when Dapol started selling it as a stand alone.


Craig