mechman wrote:Fil wrote:Thanks Norm.
Where am I measuring the 11/16 between?
Is that the distance between the calibration mark and the spot face when the screw on the governor arm is just touching the end of the rack spindle?
And is that with the governor fully forward (away from the flywheel) or fully back (towards the flywheel?)
Sorry if I'm being a bit dense!
Fil.
It should be 13/16" from the calibration mark to the spot face when the rack spindle is touching the governor when it's at it's furthest point from the fly wheel. Also I have manually adjusted the setting when things didn't go according to the book, Due to wear etc but never needed the top end of the Rev range.
Norm
Edit.
Sorry the book says that it should be the other way round, 1/2" calibration mark when governor is at furthest point and spill timing is at 13/16"
Norm.