The Classic Machinery Network

I don't suppose anyone has a rear wheel 16 x 4 ( 3 bolt pattern) that will fit a winget dumper? I have been In contact with winget, they can get one made! but it's very expensive. I'm in the Nottinghamshire area but happy to travel Ian

Is the centre damaged or the rim?

Hi essexpete, it's the rim about 1/3 is rotted out. I'm thinking about cutting out the rot and replacing it. But obviously a replacement wheel would be loads easier! But I suppose these challenges make us who we are, but stronger!

I have no idea but, would some six stud types fit on the 3 stud?

Another option is to cut out the good 3 stud hole wheel centre and weld it into a good rim. Sounds scarey but easy to do.

I don't have a spare one, but you might want to check out local scrap yards or online marketplaces like eBay. Sometimes, you can find used parts at a more reasonable price.

Might also try FaceAche Market Place. I have been finding some treasures there of late.

whhh45 wrote:I don't have a spare one, but you might want to check out local scrap yards or online marketplaces like eBay. Sometimes, you can find used parts at a more reasonable price.

Thanks I've been looking all over the place

dont give up. Sometimes parts take a bit of time so start attending swap meets and rallies as well as the online stuff.