I have an old hymac 370c an have been having problems with ram seals but today I have a new problem.
The right hand slew ram has what looks like a little pressure relief valve on the end of the ram and each time I use the slew for the backactor I get a jet of hyd fluid any ideas
Regards Telboy
Hymac 370c
-
- Moderator
- Posts: 8677
- Joined: Sun Aug 05, 2007 8:36 pm
- Real name: Jeremy Rowland
- Has thanked: 1873 times
- Been thanked: 1692 times
Re: Hymac 370c
Hi Terry,
Whilst I'm no expert on hydraulics it sounds to me that you either have too much oil in your system or a relief valve that is not functioning correctly. This would explain why you are continually blowing ram seals and the jet of hydraulic oil from your slew ram sounds like there is too much pressure in the system
Just an idea hope it helps.
Jeremy
Whilst I'm no expert on hydraulics it sounds to me that you either have too much oil in your system or a relief valve that is not functioning correctly. This would explain why you are continually blowing ram seals and the jet of hydraulic oil from your slew ram sounds like there is too much pressure in the system
Just an idea hope it helps.
Jeremy
-
- Posts: 5422
- Joined: Tue Jun 12, 2007 10:10 pm
- Real name: Nick Drew
- Has thanked: 437 times
- Been thanked: 208 times
Re: Hymac 370c
Hi Terry,
And a big welcome to CMN
I think this is one for our resident mechanical expert tctractors
Nick
And a big welcome to CMN
I think this is one for our resident mechanical expert tctractors
Nick
Digger Man Blog at Earthmovers http://www.earthmoversmagazine.co.uk/?page_id=3092
Digger Man Blog Facebook page, https://www.facebook.com/groups/1422908344617046/
You Tube Channel https://www.youtube.com/channel/UC_PJQrzRauAM6ANLxhhcGFA
Digger Man Blog Facebook page, https://www.facebook.com/groups/1422908344617046/
You Tube Channel https://www.youtube.com/channel/UC_PJQrzRauAM6ANLxhhcGFA
-
- Posts: 6393
- Joined: Mon Nov 03, 2008 8:06 pm
- Real name: MARTYN WILLIAMS
- Location: South Wales
- Has thanked: 296 times
- Been thanked: 359 times
Re: Hymac 370c
I think you will need to check oil level/grade of oil and correct pressure of your hydraulics,are the relief valves set too high.Or may be just old seals and o rings.On some machines you will have a swivel joint at the end of your hoses.The o rings may be perished or gone hard.
Hope this helps.
Hope this helps.
Who is online
Users browsing this forum: No registered users and 44 guests