Re: New owner of Hymac 580 B
Posted: Fri Feb 02, 2018 9:41 pm
First i had to get the shims in place again
Then in with thick loctite before I put it together
Shims in place. It got really tight!
Finally i welded a washer over it to secure it even more
The last days we got very much of snow so i had to clear that before i could continue today
Than i only had the fitting of the new bearings left. With wind and -11 outside it wasnt cozy all the time, but i got warm inside when i saw the result
Bearings fitted
This video shows the results. All the clearance removed! ( I really tried to embed the video using the function on this page, but i didnt get it to work )
https://youtu.be/REUwhCFFfkQ