Search found 47 matches
- Thu Apr 17, 2014 9:02 pm
- Forum: Loaders/Backhoes
- Topic: JCB 3C MK III repair
- Replies: 16
- Views: 11455
Re: JCB 3C MK III repair
the rear one is a bleed screw the other bleed screw is at the other side at the rear of the throttle arm. bowden cable may be a cold start what fits under pump but dont worry about it.
- Thu Apr 17, 2014 10:54 am
- Forum: Loaders/Backhoes
- Topic: JCB 3C MK III repair
- Replies: 16
- Views: 11455
Re: JCB 3C MK III repair
On the fuel filter there is one large bolt/bleed screw facing radiator loosen that then pump fuel by using the hand lever on the fuel pump on the side of the engine until fuel comes out of the bleed screw then tighten it .Next go to your fuel pump you will see two small bleed screws one on the top a...
- Mon Mar 31, 2014 6:23 pm
- Forum: Loaders/Backhoes
- Topic: jcb 3c111 ram seals
- Replies: 3
- Views: 2037
Re: jcb 3c111 ram seals
PMd youSteelfab wrote:Hi I have some spare seal kits if you need them
- Fri Mar 28, 2014 8:12 pm
- Forum: Loaders/Backhoes
- Topic: dirt in fuel
- Replies: 1
- Views: 1361
dirt in fuel
I bet this is why its been cutting out
- Fri Mar 28, 2014 8:08 pm
- Forum: Photo Competitions
- Topic: CMN Photo Competition March 2014
- Replies: 26
- Views: 13319
Re: CMN Photo Competition March 2014
Floods what floods
- Thu Mar 27, 2014 7:24 pm
- Forum: Loaders/Backhoes
- Topic: jcb 3c111 ram seals
- Replies: 3
- Views: 2037
jcb 3c111 ram seals
does anyone know if all three rams on the rear actor are the same or if the seals are the same my bucket ram is leaking badly
- Fri Mar 21, 2014 9:48 am
- Forum: Loaders/Backhoes
- Topic: how not to stop a jcb
- Replies: 5
- Views: 3076
- Wed Mar 05, 2014 9:57 am
- Forum: Photo Competitions
- Topic: CMN Photo Competition Februar 2014
- Replies: 37
- Views: 17902
- Fri Feb 21, 2014 9:54 am
- Forum: Loaders/Backhoes
- Topic: spun a bearing jcb 3c111
- Replies: 5
- Views: 2692
Re: spun a bearing jcb 3c111
Cheers jeremy ive been looking for a engine but they seem a bit thin on the ground or need rebuilding
- Thu Feb 20, 2014 7:43 pm
- Forum: Loaders/Backhoes
- Topic: spun a bearing jcb 3c111
- Replies: 5
- Views: 2692
spun a bearing jcb 3c111
Where do i start :( my jcb 3c 111 has always had a knocking engine but always started and run on all four cylinders so i left well alone anyway i was using it yesterday and it started to make a noise what i would have said sounded like piston ring scraping the bore so i stopped it when i came to sta...