The Classic Machinery Network

Thanks for the tip, wood sounds easier than the route I was thinking.

I was looking into threaded rod and heaps of big washers filed down to make the stepped shaft.

It is a two stage clutch, drive plate at the flywheel.

I took the clutch and flywheel to a clutch expert, he machined the surfaces and relined the plates, he also did all the required adjustments for $580 NZD.

All I need now is to make an alignment tool to get it all back together.

Here is a picture of the stand I made to hold and roll the front away

Tractor in good working order http://www.classicmachinery.net/forum/images/userpix/67660_2J71MZOZIT4WG1579667448.jpg After it stopped moving I diagnosed the clutch was the issue so preceded to remove it. :dizzy: http://www.classicmachinery.net/forum/images/userpix/67660_2CVOI5LJICISO1579667449.jpg h...

I have split my, what I think is a Fiat 650 in half to replace the clutch.
Does anyone have some specs or a manual for this please?
Seems like an old or rare model.